Using the AirPro Neck Traction for neck pain relief

AirPro Neck Traction - 5 Layers

Model: AirPro Neck Traction-5

Rises to Max. Ht.: 14cm / 5.5 in.
Traction force: 0 - 110 lbs

AirPro Neck Traction - 7 Layers

Model: AirPro Neck Traction-7

Rises to Max. Ht.: 20cm / 7.9 in.
Traction force: 0 - 154 lbs

The AirPro Neck Traction is indicated for muscle tension and tightness, neck pain, osteoarthritis, pinched nerves, tension headaches, swollen discs, supporting the neck in correct alignment, and for degenerative discs or joints. Consult a medical professional in the case of preexisting conditions.

1.	Safe, anatomically correct traction
2.	Gives the head and neck needed support, in full comfort
3.	Pressure is distributed evenly and gently
4.	Sustains the upper spine in its normal curvature
5.	Gradual release of traction pressure
6.	Simple to put on and convenient for older people
7.	Portability, low weight, can go with you anywhere

Simply place the AirPro Neck Traction device comfortably around your neck and inflate with air using the high efficiency hand pump to gradually raise the level to a comfortable stretch. When the air neck traction is fully inflated, it will elongate to support the weight of the head allowing tight neck muscles to relax.

Further inflation will stretch the neck and shoulder muscles while taking pressure off the discs, joints nerves and blood vessels.


1. Seperate the AirPro Neck Traction layers and grasp as illustrated.	2. Place the multi-layers AirPro Neck Traction around the neck as shown with layers seperated, the join the left and right sides together.

3. Push the roller valve (blocker) towards the large end of the valve seat, then turn the air valve clockwise to tighten it.	4. Squeeze the hand bulb to inflate the multi-layered chambers of the AirPro Neck Traction to the desired level.

5. Push the roller valve (blocker) towards the small end of the valve seat, then turn the air valve clockwise to loosen it.	6. Push the roller valve (blocker) towards the large end of the valve seat slowly to let air out.

AirPro Neck Traction Treatment Guideline Table

Traction	Pressure (psi)	Force (lbs)	Pumps To Inflate	Duration of Traction
Continuous Adjustment	to 1.5	to 22	18 to 24	long duration
Minor	1.5 to 4.4	22 to 53	24 to 36	15 to 30 min
Moderate	4.4 to 7.3	53 to 88	36 to 48	5 to 15 min
Major	7.3 to 10.2	88 to 125	48 to 60	3 to 5 min
Special	10.2 and above	125 and above	60 and above	up to 3 min

1. Inflation Bulb
2. Inflation Bulb Screw
3. Tube
4. Blocker (Valve)
5. Valve Seat
6. Lining for Jaw
7. Multi - layer Air Chamber

A. Detail of valve for blocking the air flow
A1 Open
A2 Closed

B. Detail of the inflation bulb screw
B1 Turn for deflation
B2 Turn for inflation

1.	Place the AirPro Neck Traction around your neck and Velcro it together in the back (after ensuring correct fit and position).
2.	Squeeze the inflation bulb until you begin feeling the desired amount of stretch/relief. Start with a gentle stretch for 1-2 minutes at first. Gradually increase as your neck becomes more flexible.
3.	Slowly open the air release valve to release the pressure. Then remove the device.